AUTONET TV

Automotive Tips from Gilmore's Auto Service: Where Should New Tires Be Placed

When Walnut Creek drivers need to replace tires, they need to know how many they should get and on which axle they should be placed. Replacing a damaged tire may leave you with three others with significant wear, which could affect your traction control, stability control and anti-lock brake systems.

If you can’t afford to replace all four tires at once, you should at least replace two on the same axle. New tires should always be put on the rear axle for stability in slippery conditions. Your friendly and professional Gilmore's Auto Service tire professional can help you know when your worn tires should be replaced, if you can have a damaged tire repaired as well as selecting the right tires for your needs.

Give us a call.

Gilmore's Auto Service
2151 N Broadway
Walnut Creek, CA 94596
(925) 939-9430
http://www.gilmoresauto.net

Breathe New Life into Your Engine (MAF sensor replacement)

If you’ve noticed your vehicle is hard to start, stalling, or has lost power, the culprit may be a part with an odd name: the MAF sensor.  You may have never even heard of a MAF sensor, but it’s important that it be working correctly, or you may be experiencing some fairly significant engine issues.

All vehicles bring in air and direct it through an air filter before it goes into your engine, where it mixes with fuel to provide power to get you going. There’s a tube-like device with a sensor inside it that measures how much of that mass of air is passing through. That’s why it’s called a mass air flow sensor, or MAF sensor.  If the MAF sensor isn’t working right, the engine’s computer can’t figure out the right amount of fuel to mix with it, and your engine may hesitate or stall.  Sometimes this will cause your Check Engine Light to come on, and any time it does that, make sure you have your vehicle checked by a professional, so you’ll know what’s going on.

When you take your vehicle into your service facility, a technician will thoroughly check the system to see just where the problems are.  If your air filter is dirty, your MAF sensor may get dirty too, which might be causing the problems.  You may find your fuel economy isn’t what it used to be either.

There are other things that can cause the same symptoms, too, such as a leak in a vacuum hose. It’s also possible that the electrical connector between the MAF sensor and the engine has broken. 

The technician can use electronic diagnostic equipment to help pinpoint the exact problem or problems, replace worn parts, and test drive your vehicle to make sure it’s working correctly.

It’s also a good idea to make sure your air filter is changed regularly. A dirty air filter can contribute to a MAF sensor failure. One of the big benefits of having your vehicle regularly maintained at one facility, is they know your vehicle. So, they keep track of which of your vehicle’s parts should be periodically replaced before problems develop. 

If you keep clean air heading into your engine, it can help your engine work efficiently, and with the power it was engineered to deliver. Isn’t that a breath of fresh air?

Gilmore's Auto Service
2151 N Broadway
Walnut Creek, CA 94596
(925) 939-9430
http://www.gilmoresauto.net

Improve Your Night Vision When Driving in Walnut Creek

Night driving in Walnut Creek is not as safe as daylight driving as evidenced by the increased accident rate at night. Much of that is simply because it's dark outside.

Visibility is important to safe driving. Ninety percent of our driving decisions are based on what we see. And at night, we just can't see as much as we can during the day. In fact, if you have 20/20 vision during the day, your night vision is only 20/50. To translate, that means that an object you can clearly see 50 feet away during daylight, only becomes visible to you at 20 feet at night.

Reaction time is also related to visibility. Walnut Creek motorists don't react to a situation until they see it. So at night, we're reacting to situations later just because it takes longer to see them. But we don't have to stop driving at night to stay safe. We just need to practice some preventive maintenance and vehicle care that will maximize our night vision.

The most crucial item that helps us see while driving at night is, of course, our headlamps. Walnut Creek drivers should ensure that their headlamps are as bright as they can be. Headlamps dim over time, but they do it so gradually that it's difficult to notice. Because of this, experts recommend replacing headlamps once a year.

That's good auto advice for Walnut Creek drivers, but it doesn't apply to all headlamps. Some vehicles use HID, or high-intensity discharge, headlamps. These are bright headlamps that are designed to last for the entire life of a vehicle. Depending on your vehicle, you may be able to upgrade to HID headlamps. Consult with your friendly service advisor at Gilmore's Auto Service to learn your options.

Most vehicles use standard or halogen headlamps. If you use standard headlamps, you might want to upgrade to halogen, which offers a brighter headlight. Halogen headlamps come in a variety of grades, so evaluate your options the next time you replace your headlamps and upgrade if you want a better light.

It won't do much good to upgrade or replace your headlamps, however, if your headlight lens is dirty or yellowed. Studies have shown that about 90% of the vehicles on the road have impaired headlights due to dirty or yellowed headlight covers. You should get into the habit of washing your headlights every time you gas up. Simply grab the window washer squeegee, run it over your windows, then swish it across your covers. No cost involved at all.

Plastic headlamp lenses yellow or become hazy over time. If your lenses have this problem, they can be restored with a special polishing process. You may be able to get this done at your Walnut Creek service center. If not, they should be able to tell you where you can.

Now, what good is a quality headlamp if you can't see through your windshield? Your windshield needs to be clean and streak-free if you plan on driving at night in Walnut Creek. You should also keep your windshield washer fluid replenished and your wipers in good condition.

Wiper blades should actually be replaced twice a year. The changing of the seasons at spring and fall, or Daylight Saving Time, can be a good reminder to do this. And while you're at it, fall is the perfect time to replace your headlamps. Those long winter nights add up to a lot more night driving for people in Walnut Creek.

Stay alert. Stay awake. And keep those headlamps burning bright.

Gilmore's Auto Service
2151 N Broadway
Walnut Creek, CA 94596
(925) 939-9430
http://www.gilmoresauto.net

Pinch Petroleum Pennies! (Fuel Saving Tips)

If you saw a dollar bill on the ground, you'd pick it up, right? Well, whether you find that dollar on the ground or in savings at the gas pump, money is money, and here are some ways to hold on to more of it.

Slowing down is the easiest way to save fuel, especially for every speed increase over 50 mph/80 k/hr.  Tone down the speed, turn up the cash savings.  Drive smoothly (not like a race car driver) and you'll also save money in fuel.  Aggressive, fast-start, jerky-stop habits are just pulling the bucks out of your wallet about a third more than if you drove just a little more gently.  Oh, and cruise control can help with that smooth, steady speed, so use it on the highway. Bonus!

Are you hauling around a set of dumbbells or a box of books? That extra weight is costing you dough.  Store them somewhere else.  When's the last time you checked to see your tires were inflated properly? That's another money saver and makes your vehicle safer.

An idle thought… don't idle any longer than you have to.  If you will be idling for more than 30 seconds you'll save money by turning off the engine and re-starting it.  More and more of the latest vehicles now do this automatically.

Some like it cold.  But air conditioning uses a lot of extra fuel.  If you can live with the cabin at 72 on a hot day rather than turned down to arctic freeze levels, you'll save some cool cash.  Turn off the A/C all together can save you from 5-20 percent

The key to a fuel-efficient vehicle is keeping it well maintained.  If your spark plugs are old, your belts frayed and your brake pads worn, you're just throwing away fuel.  Try a few of these gas-saving suggestions and while you're at it, you'll be helping to reduce your carbon footprint that will help everyone on Planet Earth.

Gilmore's Auto Service
2151 N Broadway
Walnut Creek, CA 94596
(925) 939-9430
http://www.gilmoresauto.net

Going (Lug) Nuts (Lug Nut Replacement)

Here's a part of your vehicle you probably don't think about much: lug nuts.  They're what fasten your wheels onto your axles.  Pretty important, right? In order to take the wheels off your vehicle to service the brakes, rotate the tires, etc., the lug nuts have to be in good shape so a wrench will grip them tightly. 

Because lug nuts are on your wheels, they are exposed to all the elements of the road (salt, water, grime) and really take a beating. Unfortunately, some manufacturers have made them out of two different metals.  Underneath is the working part of the lug nut, made of steel.  On top is the decorative (the "good looking") part, made out of chrome, stainless steel or aluminum.  After a while, the steel part begins to corrode and expands.  That changes the shape of the outer cap, sometimes rounding off the hexagonal edges and making it hard (if not impossible) to either loosen or tighten the lug nuts since the wrench won't fit any more. 

The reason that's so important is those lug nuts must be functional, especially if you find you have a flat tire somewhere on the road.  If the wheel can't come off to be swapped with a spare, it leaves few options, one of which is your vehicle may have to be towed.  All that for corroded lug nuts!

When you take your vehicle in for service, the technician who works on it keeps an eye on many things, especially if he or she is removing wheels.  It's not unusual for your service advisor to recommend you replace several lug nuts at once since some corrode at a different rate than others. Your repair facility is trying to help you avoid driving a vehicle that has wheels that can't easily be taken off when they need to be.

The good news is there are one-piece lug nuts that don't have the problem the two-piece lug nuts have, so replacing them could eliminate that from happening again any time soon.  And that's not "nuts" at all.

Gilmore's Auto Service
2151 N Broadway
Walnut Creek, CA 94596
(925) 939-9430
http://www.gilmoresauto.net